Command Details: Get_Configuration_Data
Category
Extended
Details
Command Code: | 13h |
Valid for: | Object |
Description
If the configuration data is requested from the network, the Anybus will issue this command to the application. The application shall send the stored configuration data in the response message.
Segmentation is used since the telegram length on the host interface is limited. The maximum total amount of configuration data that will be accepted by the module is 458 bytes.
This command must be implemented in order to support Configuration Data. If not implemented, the request will be rejected by the Anybus module.
Command Details
Field
Contents
Comments
CmdExt[0]
00h
-
CmdExt[1]
00h
-
MsgData[0... n]
-
No extended message data
Response Details (Success)
Field
Contents
Comments
CmdExt[0]
00h
(reserved, set to zero)
CmdExt[1]
Segmentation Control bits
MsgData[0 - n]
Status
Configuration data from the application
Response Details (Error)
Field
Contents
Comments
CmdExt[0]
00h
(reserved, set to zero)
CmdExt[1]
Segmentation Control bits
MsgData[0]
Status
Anybus protocol error code